Driver for KISS communications over serial interfaces.
WARNING: KISS.EXE should only be used to attach another computer. It
is not able to drive a KISS TNC. Parameters such as TxDelay and full/half
duplex are not forwarded. The only use of this driver is PC to PC or PC
to RMNC coupling!
16550 support (FIFO mode) is implemented. The KISS baudrate must be
specified with the FSET MODE command. The RMNC KISS CRC mode is supported
and autimatically activated if the peer imposes CRC checking. CRC may be
forced with the mode parameter 'c'. All other mode parameters are ignored.
COM1-4 may be specified directly at driver start. Other port addresses
or IRQ numbers are optional. The address and the interrupt number may be
specified either decimal or hexadecimal prefixed with '0x'. Explicit port
and irq settings take pecedence over the defaults.
